Systematic Evaluation of Cd(II) Adsorption onto CTS–Polyester-Gly5 Crosslinked Polymeric Spheres: Operating Parameters, Equilibrium, Kinetic Modeling, and Thermodynamics
Keywords:
Cd(II) adsorption; CTS–Polyester-Gly5; adsorption isotherms; adsorption kinetics; thermodynamic analysisAbstract
The adsorption of Cd(II) from aqueous media by CTS–Polyester-Gly5 crosslinked polymeric spheres was examined under different operating conditions. The influence of solution pH, adsorbent dosage, contact time, Cd(II) concentration, and temperature was assessed. The highest experimentally measured adsorption capacity, approximately 28.5–29 mg g⁻¹, was obtained at pH 6. At an adsorbent dosage of 2 g L⁻¹, the removal efficiency was approximately 85%. Uptake was fastest during. the early contact period. and then increased more gradually, approaching a near-equilibrium condition within 720–840 min. Of the isotherm models examined, Langmuir gave the highest coefficient of determination (R² = 0.9923), corresponding to a calculated maximum. capacity of about 34.6 mg g⁻¹. For the kinetic data, the pseudo-second-order (PSO) model produced a higher R² (0.9956) than the pseudo-first-order (PFO) model (0.9420); however, the PSO-calculated equilibrium capacity was higher than the experimental value. Raising the temperature from 25 to 45 °C increased the adsorption capacity from approximately 28.5 to 31 mg g⁻¹ and the removal efficiency after 840 min from about 78% to 89%. The thermodynamic parameters were ΔH° = +33.90 kJ mol⁻¹ and ΔS° = +117.79 J mol⁻¹ K⁻¹, while ΔG° was −1.22, −2.35, and −3.58 kJ mol⁻¹ at 298, 308, and 318 K, respectively. These findings indicate that Cd(II) uptake by CTS–Polyester-Gly5 was favored at higher temperatures under the conditions investigated. The results support further evaluation of these crosslinked. spheres as a candidate adsorbent. for Cd(II)-contaminated water.
Published
How to Cite
Issue
Section

This work is licensed under a Creative Commons Attribution 4.0 International License.